INSTRUCTIONS FOR PNEUMATIC FLUID EXTRACTOR/DISPENSER
- Share
- Issue Time
- Jun 15,2022
Pneumatic Fluid Extractor (DN-G1034)
For the extraction and refilling of gearbox/engine oils from motor vehicles,motor bikes,marine engines,generators etc
How to Use
Check the product before using the tools
make sure all parts are in place and there are no cracked,broken or loose parts.
use the correct air inlet coupler as there are different tyoes in different countries
make sure the trigger is in the "OFF" postition.
make sure the extractor/dispense control knob is in the right position.
Warning! Before use you must check that the fluid you intend to use is safe to be dispensed with this type of machinery.DO NOT use with volatile or explosive prodcuts(eg.oetrik/gasonline or there is a significant risk or explosion and personal injury)
Extraction
1.Turn the extract knob ④ anti-clockwise to loosen2.Connect the relevant tube onto the inlet/outlet coupler⑥
3.Connect the tool to the air supply
4.Push the trigger ① to work (Note:release the trigger when you require the unit to stop working
Dispense
1.Turn the fill/extract knob ④ clockwise to tighten
2.Connect the relevant tube onto the inlet/outlet coupler⑥
3.Connect to the air supply and start the process there is a safety valve on the extractor/dispenser
4.Push the trigger ① to start the extractor/dispenser
5.you can control the fluid extraction speed by adjusting the control valve ball valve when using tube ⑧