instruction for ball joint removal tool (Fork type)
- Share
- Issue Time
- Nov 9,2022
Ball Joint Separator (fork type)
Can be used for tie rod end, pitman arm and ball joint removal.
This type of tool (wedge) will damage the dust seal on the parts that are removed with this tool. If you are reusing any of these parts use the damage free type of tool.
INSTRUCTIONS:
Always wear safety glasses and gloves.
1. Loosen fastener nut, but do not remove completely.
2. Place “wedge” between the two parts being separated.
3. Using hammer strike wedge until it separates.
4. Remove the fastener nut completely and replace the part.
Note: Always replace locking hardware-cotter keys, etc.