Replace the Ball Joint of an Ford Cars

Replace the Ball Joint of an Ford Cars

Summary

How to Replace the Ball Joint of an Ford Cars

How to Replace the Ball Joints on a Ford F150


Loosen the front wheel lug nuts by turning them 1/4 turn counterclockwise with a tire wrench. However, be careful that you do not unseat the wheel from the wheel hub and the full weight of the truck is still over the tires.

Place the jack under the front jack point and jack up the F-150. The front jack point is located near the radiator and is an extension of the frame. On the F-150, the jack point is essentially the front crossmember.

Finish removing the lug nuts and pull the wheels off.

Remove the cotter pin and axle nut that holds the outer tie rod end. This nut sits in the center of the wheel hub assembly. Pull the cotter pin out using a pair of pliers. The nut will require some force, but can be removed with a socket wrench.

Push the axle in by hitting it with a rubber mallet. Now that the outer tie rod end nut has been removed, the axle should slide in enough for you to slide the hub assembly forward.

Locate the ball joint. As its name suggests, it looks like ball and cup joint. It will have a rubber protective boot on it. There is an upper and lower ball joint on the F-150, so you'll need to do them both, but the process is the same for both ball joints.

Remove the upper and lower mounting bolts on the caliper with a socket wrench and pull the caliper off the brake rotor. Secure the caliper assembly to the coil springs above the brake assembly with zip-ties and pull the brake rotor off the wheel hub.

Remove the cotter pin and mounting nut from the upper ball joint. The cotter pin must be pulled out with a pair of pliers. The nut can be removed with a socket wrench.

Wedge the ball joint removal tool-also called a pickle fork-between the ball joint and the steering knuckle. Bang on the handle of the pickle fork to separate the ball joint from the steering knuckle

Repeat steps 6 and 7 for the lower ball joint.

Push the axle into the hub to back it out and pull the hub away from the axle. In the process, you should be removing the knuckle as well.

Remove the snap ring on the lower ball joint by pressing the clip apart and pulling up on the clip with a pair of pliers.

Place the head of the ball joint press tool over the top of the ball joint and tighten the clamp until the ball joint is pressed out of the control arm. Note the orientation of the ball joint as you are removing it

Install the new ball joint. Installation is the reverse of removal. When pressing the new joint in, make sure that the ball joint press tool is pressing the joint straight into the control arm.

Re-install the snap ring.